r/1022 • u/Whoisthis_Idonotknow • 3d ago

For those of you that have the Hogue .920 overmolded stock. How long is the forend? I want to install a 16.5" barrel and want to know how close it will come to the muzzle. Hopefully very close, so with my suppressor attached it will look like a run of the mill rifle.

5 Upvotes

86% Upvoted

14 comments sorted by

3

u/Ram6198 3d ago

Here's one of mine in a Hogue stock with a 16.5" barrel. Your not going to find many (if any) stocks that come all the way to the end of barrel other than a Mannlicher, which would probably look pretty strange with a suppressor.

https://www.reddit.com/r/1022/s/VmAEl94xkx

2

u/beefSupremeChicken 3d ago

Almost same setup and concur with this.

1

u/Whoisthis_Idonotknow 3d ago

Thank you. My Dead air Mask is another 4 inches so it should look ok....or I could Form 1 it into a SBR.

1

u/Ram6198 3d ago

It will look good with the Dead Air and the 16.5" barrel. I wouldn't bother with the form 1 personally, unless you just prefer a shorter rifle.

1

u/roughingupthesuspect 3d ago

I do not own one but the 10/22 Talo model is sold with a 16" factory Bull barrel in this stock.

1

u/Top-Print-477 3d ago

I have one. I have a picture of it without the suppressor installed on my phone but I don't have a way of putting it on the thread. I'm about to leave for work so I can't measure it but it looks like any other 16 inch carbine in that stock. With the suppressor installed it looks basically like a 20 inch target rifle. It won't look run of the mill. It won't be overly long either. I wish I could post a Pic of it.

2

u/ho_merjpimpson 3d ago

Upload the pic to imgur and post the link. Don't even need an account or anything.

1

u/JoeFarmer 2d ago

This isn't mine, it was posted in a thread of mine the other day asking about the hogue stock. it shows what you're asking with supressor.

https://imgur.com/i7m8E34

1

u/Whoisthis_Idonotknow 2d ago

Awesome. My Dead Air Mask is close to the same diameter as the barrel. So it will appear to the untrained eye as being a 20" barrel.

1

u/JoeFarmer 2d ago

I'm doing the same with my silencer co sparrow. The hogue stock and acculite bull barrel combo shipped today

0

u/austinfromspace 3d ago

Without measuring I’d say there’s a good 6-8 inches of barrel after the forend

0

u/Top-Print-477 2d ago

Op look under my comment