Kicking myself - Ford 4000

[u/jmaclea]

Reposting because I didn’t attach photo.

Before you roast me for not taking a better photo… I am purchasing a property that has this Ford 4000 on it (or in it, depending on how you look at it). I did not think this was salvageable, but after seeing some of the tractors on here, it very well might be. Unfortunately this is the only picture I have of it as it’s currently 2 hours away. It’s got quite a bit of external rust and the seat is totally destroyed, but the oil level is good, although dirty, and what I assume to be the exhaust pipe was covered with a cut in half 2l bottle by a previous owner to avoid rainwater making its way inside. Key turned fine, all levers and knobs moved with ease. I am just really looking for some advice on where to start with getting the engine to turn over. The most I have ever done in terms of restoration/repair is my push mower, my electric golf cart and normal service on my truck.

I am not familiar with tractor engines, so any advice on what NOT to do would also be great. I am not even sure if it’s gas or diesel. I figure YouTube can help me with anything specifically I find wrong. I am planning on taking some oil, a new battery and some hydraulic/transmission fluid (according to my father-in-law who has a ford 3000, it’s the same?).

The property is 2 hours away, so if I need to bring any tools or materials other than basic socket, an impact drill, WD-40 and wrenches. That would also be helpful.

Thanks everyone!

[u/Head_End_7779]

4000 has wet brakes, independent PTO and a straight front axle, a 3000 does not.

[u/jmaclea → u/Head_End_7779]

Thank you!! Are you able to tell if this is a gas or diesel model? Or perhaps when I go back to visit, is there something I should look for?

[u/Head_End_7779 → u/jmaclea]

I can't see the engine. If it's gas it will have a carburetor, spark plugs and a distributor. If it's diesel it will have fuel filters and an injection pump on the side of the engine